VTech vt2498 Betriebsanleitung PDF herunterladen (Seite 6)

Setup

Installation of Battery Pack in Handset

Follow the steps below:

1. Remove battery compartment cover by pressing on the indentation and

sliding downward.

2. Align the two holes in the plug with the socket pins, then snap the plug into

place.

3. Snap the battery pack in place with the wires in the lower left corner, along

the bottom of the battery pack.

4. Replace cover by sliding it up into place.

5. Place the Handset in the Charger, and allow it to charge for 12 hours.You

can use the Base Handset or Speakerphone in the meantime.

Note: If you charge the cordless Handset while the Base Unit is not connected to

power, the CHARGING LED on the cradle will flash rapidly.

Note: With a fully charged battery pack, your VT2498 Cordless Handset will

deliver up to 6 hours of continuous talk time, or up to 6 days of standby time (off

the charge cradle, but not in use). Your results can vary, and may be less than

the quoted maximums.

Getting Started

2498-manual-output.p65 3/6/03, 9:33 AM6

1 2 3 4 5 6 7 8 9 10 11 ... 42 43

Keine Kommentare

VTech vt2498 Betriebsanleitung Seite 6